2016-12-27
Switch to English①散热器的散热是以瓦作为热功率计量（W）指每组（柱）散热器在不同工况下每小时的散热量
卫浴暖气：Q=2.505△T1.348 (1200*600)
标准工况: △T=64.5℃（即进水温度95℃，出水温度70 ℃,室温18℃）
②华北地区节能墙体每平方米
集中供暖90W左右配置
独立供暖110W左右配置
房间东南向可少10%，西北向多出10%。
楼层：目前的供暖技术，对楼层没有太多的区别，但旧楼房，顶楼可适当增加10%余量。
③若安装温控阀，必须过热才可调控。散热量小了，温控阀是不起作用的，它不可能把温度调高。
① heat sink heat sink is the tile as the thermal power measurement (W) Refers to each group (column) Radiator in different conditions, the heat per hour
Bathroom heating: Q = 2.505 △ T1.348 (1200 * 600)
Standard conditions: △ T = 64.5 ℃ (that is, inlet temperature 95 ℃, water temperature 70 ℃, room temperature 18 ℃)
② North China energy-saving wall per square meter
Central heating about 90W configuration
Independent heating about 110W configuration
Room southeast to 10% less, to the northwest to 10% more.
Floor: the current heating technology, the floor is not much difference, but the old buildings, the top floor may be an appropriate increase of 10% margin.
③ If you install the thermostatic valve, you must overheat to control. The heat is small, the thermostatic valve does not work, it is impossible to increase the temperature.
上一个：铁铸材质产品有什么优势？
下一个：橙子视频直播有什么优势
